当前位置:首页 - 常见问题解答 >

分析电脑弹簧机常出现的三种故障

来源: http://www.diannaothj.com    时间:2016-04-15 16:14:54 作者:山东银丰弹簧机设备

分析电脑弹簧机常出现的三种故障:
  Analysis of computer spring machine often appear three kinds of failures:
  1、按“复位”键马达会动:伺服电机驱动器参数设定不正确。
  1, press the "reset" key motor movement: servo motor drive parameters setting is not correct.
  2、原点位置异常:接近开关本身不正常工作;接近开关接线异常;感应物接触面太小;两个原点位太近;控制器内部参数不正确(包括原点速度参数设置太高、控制器解析参数设置错误等)。
  2, abnormal origin position: proximity switch itself does not work properly; Proximity switch wiring anomaly; Induction objects contact area is too small; Too close to two origin; Inside the controller parameters is not correct (including the origin rate parameter is set too high, and resolution of the controller parameter setting error, etc.).
  3、机器在正常运行中出现“暂停”状态: 出现此种状态有两种情况:
  3, the machine in the normal operation of the "pause" status: this state has two cases:
  (1)当线料用完、I13断开或断线时,会在电脑右下角出现“线料用完请处理”提示,并停机在“暂停”状态;
电脑弹簧机

  (1) when the line is expected to run out and I13 disconnect or wire, will appear in the computer at the bottom right "line is finished, please deal with" prompt, and stop on the "pause" state;
  (2)当有外部杂信号干扰到I13(即本来是常亮的I13号灯会出现有时亮有时灭就是有干扰)或者线架没有能够通过钢线与机器形成良好的回路(即有短暂的线架与机器没有导通现象),不会出现“线料用完请处理”提示,只是停机在“暂停”状态。
  (2) when there is external noise signal interference to I13 (that is, it is normally on I13 number will appear and sometimes there is interference on sometimes is) or wire rack hasn't been able to loop through steel wire and machine to form a good (i.e., a short line and machine without conduction phenomenon), there will be no "line is finished, please deal with" prompt, just stop at "suspended" status.
上一篇:在日常生活中如何对电脑弹簧机保养呢?
下一篇:电脑弹簧机旋转体的平衡是装配精度中的一项重要要求
联系我们