当前位置:首页 - 新闻动态 > 公司公告 >

数控弹簧机的日常三大维护系统

来源: http://www.diannaothj.com    时间:2016-05-05 16:12:10 作者:山东银丰弹簧机设备

1、运行机制的维护操作步骤:关掉电源;在用棉织物清洗机构和电机,并涂防锈油。滑块运动精度的幻灯片对象,不使用高粘度油,只使用滑油润滑,以免影响滑块的直线运动。注意:不要使用空气喷枪清洗,为了避免灰尘和碎片,要保留溜槽或旋转结构的间隙。每六个月分别组织在1-4黄油嘴增加轴承润滑脂。
1, the operation mechanism of the maintenance steps: turn off the power supply; in the use of cotton fabric cleaning mechanism and motor, and coated with anti rust oil. Slide motion accuracy of the slide object, do not use high viscosity oil, only use the lubricating oil, so as not to affect the linear movement of the slider. Note: do not use air gun cleaning, in order to avoid dust and debris, to retain the clearance chute or rotary structure. Tissue in the 1-4 grease mouth to increase the bearing grease every six months.
2、齿轮传动的润滑系统的维护:齿轮润滑系统分为X和Y轴,和油罐是刚刚接触齿面。油不多,6个月1次检查机油和燃油箱,每六个月更换周期,油保养。需要注意的是:使用完整的1000小时的新机,请务必更新新的循环油。
2, gear transmission lubrication system maintenance: gear lubrication system is divided into Y and X shaft, and the oil tank is just contact the tooth surface. Oil is not much, 6 months, 1 times to check the oil and fuel tank, the replacement cycle every six months, oil maintenance. Need to pay attention to is: the use of a complete 1000 hours of the new machine, please be sure to update the new cycle of oil.
3、送丝系统:保持进给伺服电机来防止维护,使用石油和天然气的清洁,灰尘落入伺服电机或编码器,造成机械损伤。至少每六个月进行维修或根据机器生产的数量,并在同一时间替换换行操作。
3, wire feeding system: to maintain the feed servo motor to prevent maintenance, the use of oil and natural gas cleaning, dust fall into the servo motor or encoder, resulting in mechanical damage. According to the number of machine maintenance or production of at least every six months, and replace the line operating at the same time.
本文来自:电脑弹簧机更多的相关内容请点击:http://www.diannaothj.com我们欢迎您的访问。
This article from: computer spring machine more relevant content please click: http://www.diannaothj.com we welcome your visit.

上一篇:查找电脑压簧机风扇转动声音的方法
下一篇:对电脑弹簧机开机的操作小妙招
联系我们