当前位置:首页 - 新闻动态 > 公司公告 >

弹簧机械不归零现象解决方法

来源: http://www.diannaothj.com    时间:2016-10-09 14:16:03 作者:山东银丰弹簧机设备

若是弹簧机每次归零以后零点位置都不准确,那就可能是驱动参数的问题。考虑一下电子齿轮比设置是否正确,每个机器都有特定的参数比,不过一般参数都是在机器出厂之前就设置好了,要是厂家技术员不在场建议不要轻易改动。
If the spring machine after each zero zero position is not accurate, it may be the problem of driving parameters. Consider the electronic gear ratio is set correctly, each machine has a specific parameter, but the general parameters are in the factory before the machine is set up, if the factory technician is not present suggestions don't change.
还有一种情况就是观察屏幕情况。讲弹簧机械正常的归 零作用,同时要观察屏幕右上角的三角是否有反向动作。如果有此动作就表示电路板已经损坏,这是用户不能解决的问题需要与厂家联系。若是没有反向的动作,那 就是用户自己能解决的。
There is also a situation is to observe the situation of the screen. Stresses the normal return of the mechanical spring, while the upper right corner of the screen to observe whether the triangle has a reverse action. If you have this action that the board has been damaged, this is the user can not solve the problem with the manufacturers need to contact. If there is no reverse action, that is the user can solve their own.
只需要打开弹簧机的后盖,重做归零的动作即可,同时注意观察近接开关指示灯在机器正常运转的一周过程中是否正常亮。如不正常闪亮, 可将近接开关拿在手上,在机器归零过程中直接与机器接触,若近接开关还是不亮,就查看近接开关的电路板有没有接触不良的现象,不然可确定近接开关本身的问题。
Only need to open the back cover of the spring machine, the action can be turned back to zero, while attention to the observation of the next switch indicator light in the normal operation of the machine during the week is the normal light. If not normal flash can nearly switch in hand, the machine zero in the process of direct contact with machine, if the proximity switch is not bright, look up the circuit board of the proximity switch has no bad phenomenon, it can determine the proximity switch problem itself.
 

上一篇:四大原因导致弹簧机屏幕不显示
下一篇:往复式压缩机的弹簧固定结构组成介绍
联系我们