当前位置:首页 - 新闻动态 > 企业动态 >

弹簧机的日常使用注意事项

来源: http://www.diannaothj.com    时间:2016-04-28 17:21:22 作者:山东银丰弹簧机设备

①开启弹簧机时我们要严格按照使用步骤,生产前必须检查调试机器时所调动的所有紧固件,以避免在生产过程中发生松动、掉落或移位等现象,从而导致撞机引发机器故障或损伤。电脑弹簧机
1. To open the spring machine we want to strictly in accordance with the steps, pre production must check when the machine commissioning of the mobilization of all fasteners, in order to avoid loosening and falling or shifting phenomenon occurred in the production process, which caused the crash cause the machine breakdown or damage.
②弹簧机设备若长时间停机放置时,要尽量把送线轮松开。因为长时间的压迫会导致轴承的损伤和送线轮的轻度变形,可能会引起以后的弹簧产品的精密度的不稳定性;如果带线压紧时间搁置太长,还有可能会使钢丝变形,下次生产时会导致芯棒堵塞,甚至会损伤芯棒孔的精密性。
The spring machine equipment if long time stop is placed to try to loosen the wire feeding wheel. Because of the oppression of the long time will lead to the damage of bearings and the wire feeding wheel lightly deformed and may later cause spring product precision of instability; if the belt line pressing time aside for too long, there may be will cause the deformation of wire rope. The next production will lead to mandrel plug and may even damage the precision of the plug hole.
③学徒调试弹簧机时,师傅应尽量在现场,以减少或避免发生不必要的事故。当学徒或技术人员调试好后,师傅一定要进行检查。
When the apprentice of the spring, the master should try to reduce or avoid unnecessary accidents in the field. When the apprentice or technical personnel to debug, the master must be checked.
④弹簧机在运行中要禁止用手接触面板。弹簧产品在切断后一定要控制好掉落方向,以避免卡住刀座造成撞机现象;此外,弹簧产品有异样时必须要停止后方才进行调整和修改。
The spring machine to prohibit contact by hand in the operation panel. Spring must control the drop in the direction of cut, to avoid a collision caused by knife stuck phenomenon; in addition, there are also products of spring must stop only after the adjustment and modification.
⑤弹簧机设备发生损坏或故障时,应由专业技术人员进行检查和修正;在报修时要由相关的专业人员进行维修;要严禁无专业技术人员擅自拆卸,以免造成电脑弹簧机的二次损坏。
When damage or malfunction occurs in the spring machine equipment, by the professional and technical personnel for inspection and correction; in the repair to to repair by the relevant professional personnel; to prohibit the non professional and technical personnel to disassemble, so as not to cause secondary damage to the computer spring machine.

上一篇:弹簧机在装配过中的两大精度原则
下一篇:判断数控弹簧机的运行精度的方法
联系我们