当前位置:首页 - 新闻动态 > 企业动态 >

数控弹簧机送线故障的解决

来源: http://www.diannaothj.com    时间:2016-08-01 16:12:20 作者:山东银丰弹簧机设备

数控弹簧机开机时,送线架没工作灯显示,没鸣报时,检查送线架的开关是否处于闭合状态,进电源是否有电,电压是否是规定的电压值,保险管有没被烧毁。
Boot CNC spring machine, wire feeding shelf didn't work lights display, no sound of timekeeping, check the wire feeding shelf of the switch is in closed state, into a power if there is power, whether the voltage is the voltage value of the provisions of the insurance tube has not been burned.
当数控弹簧机送线架处于有电状态,线架不转时,应检查送线架电机是否能运转,卸下皮带试电机,查看变频器有没报警,如果不是,就要及时更换变频器; 当线架没有同步送线功能时,就是自动送线功能,检查线架电路板中的继电器是否烧坏,如果继电器的工作灯一直亮,就需要更换。
When CNC spring machine wire feeding shelf in a power on state, line frame does not turn when, should check the wire feeding shelf motor is running, remove the belt test motor and check the converter has no alarm, if not, timely replacement of inverter; when wire frame without synchronized wire function is automatically send line function, check line frame circuit board in the relay is burned, if relay working lamp has been bright, would need to be replaced.
数控弹簧机当微动开关的拉杆拉到底时,线架没有停止运转, 弹簧机的显示频上也没有出现“线架故障”之类的字样,如果有就要检查微动开关盒里的拉杆是否与两头的感应器相接触,如果没有,就要调整为接触,或者是更换感应器。
CNC spring machine when the micro switch of pull rod pull through to the end, line frame never stopped running, spring machine display frequency did not appear on the fault of line shelf like words, if you have to check the micro switch box pull rod and two sensors in contact, if not, adjust for contact or replacing inductor.
 

上一篇:弹簧机械润滑油五种添加方式
下一篇:万能弹簧机的特殊的保养内容有哪些?
联系我们