当前位置:首页 - 新闻动态 > 企业动态 >

万能弹簧机的特殊的保养内容有哪些?

来源: http://www.diannaothj.com    时间:2016-08-16 11:56:03 作者:山东银丰弹簧机设备

万能弹簧机的保养内容主要是清洁、紧固、调整、润滑、防腐。按规定周期严格执行各项保养工作,降低零件的磨损速度,消除产生故障的隐患,延长机械的使用寿命。
Universal spring machine maintenance content is mainly clean, tighten, adjustment, lubrication, corrosion protection. In accordance with the provisions of the cycle of strict implementation of the maintenance work, reduce the wear rate of parts, to eliminate the hidden trouble of failure, prolong the service life of the machine.
封存保养:应按照封存要求认真执行封存保养,减轻自然气候对长期封存设备的侵蚀。
Maintenance: should be carefully implemented in accordance with the requirements of the storage and maintenance, reduce the erosion of natural climate for long-term storage equipment.
停用保养:在机械设备因季节因素(如冬休期)等需要停用一段时间时应进行停用保养。主要做好清洁、整容、配套、防腐等工作。
Disable maintenance: in the mechanical equipment due to seasonal factors (such as winter break period) and other needs to be disabled for some time should be stopped and maintenance. Mainly to do a good job cleaning, cosmetic, supporting, anti-corrosion and other work.
走合保养:新机或大修后的机械在走合期内必须进行走合保养。万能弹簧机在规定的走合期内使用时,需按相应规程逐级递增负载及转速,并全面检查润滑、紧固情况,观察整机各部状况,发现异常及时解决。走合保养的重点是更换各部润滑油、润滑各部位、紧固各螺栓。走合期结束后进行一次二级保养。
Maintenance: the new machine or after the overhaul of machinery in the closed period must be carried out in the maintenance. Universal spring machine in the provisions of the use of the period of use, according to the corresponding rules of progressive load and speed, and a comprehensive inspection of lubrication, tightening, observe the status of the whole machine, found abnormal timely solution. The key point of the maintenance is to replace all the parts of the lubricating oil, lubricating parts, and tighten the bolts. After the end of a two level maintenance.
换季保养:机械每年入夏或入冬前应进行一次换季保养。重点是燃润系统、液压系统、冷却系统和启动系统等部分。需根据实际情况做好以下工作:更换燃润油料及液压油、调整蓄电池电解液的相对密度、采取防寒或降温措施及清洗冷却系统等
Seasonal maintenance: each summer or winter machinery should be carried out before a seasonal maintenance. The focus is on the fuel system, hydraulic system, cooling system and starting system. Need according to the actual situation do following work: replacement fuel run oil and hydraulic oil, adjust the battery electrolyte relative density and take cold or cooling measures and cleaning the cooling system etc.
 

上一篇:数控弹簧机送线故障的解决
下一篇: 弹簧机能制作的产品全攻略
联系我们